Add Favorite Set Homepage
Position:Home >> News >> Electron

Products Category

Products Tags

Fmuser Sites

Resistance and Impedance in an AC Circuit

Date:2021/10/18 21:55:56 Hits:
Want create site? Find Free WordPress Themes and plugins.The i -v relationships of resistors, capacitors, and inductors can be expressed in phasor notation. As phasors, each i-v relationship takes the form of a generalized Ohm’s law: V=IZV=IZ where the phasor quantity Z is known as impedance. For a resistor, inductor, and capacitor, the impedances are, respectively: ZR=RZL=jωLZC=1jωC=−jωCZR=RZL=jωLZC=1jωC=−jωC Combinations of resistors, inductors, and capacitance can be represented by a single equivalent impedance of the form: Z(jω)=R(jω)+jX(jω)units of Ω (ohms)Z(jω)=R(jω)+jX(jω)units of Ω (ohms) Where R (jω) and X (jω) are known as the “resistance” and “reactance” portions, respectively, of the equivalent impedance Z. Both terms are, in general, functions of frequency ω. The admittance is defined as the inverse of impedance. Y=1Zunits of S (Siemens)Y=1Zunits of S (Siemens) Consequently, all the DC circuit relations and techniques introduced in Chapter 3 can be extended to AC circuits. Thus, it is not necessary to learn new techniques and formulas to solve AC circuits; it is only necessary to learn to use the same techniques and formulas with phasors. Generalized Ohm’s Law The impedance concept reflects the fact that capacitors and inductors act as frequency- dependent resistors. Figure 1 depicts a generic AC circuit with a sinusoidal voltage source VS phasor and an impedance load Z, which is also a phasor and represents the effect of a generic network of resistors, capacitors, and inductors. Figure 1 The impedance concept The resulting current I is a phasor determined by: V=IZGeneralized Ohms Law (1)V=IZGeneralized Ohms Law (1) A specific expression for the impedance Z is found for each specific network of resistors, capacitors, and inductors attached to the source. To determine Z it is first necessary to determine the impedance of resistors, capacitors, and inductors using: Z=VIDefinition of impedance(2)Z=VIDefinition of impedance(2) Once the impedance of each resistor, capacitor, and inductor in a network is known, they can be combined in series and parallel (using the usual rules for resistors) to form an equivalent impedance “seen” by the source. Impedance of a Resistor The i-v relationship for a resistor is, of course, Ohm’s law, which in the case of sinusoidal sources is written as (see Figure 2): Figure 2 For a resistor, VR(t)=iR(t)R vR(t)=iR(t)R(3)vR(t)=iR(t)R(3) or, in phasor form, VRejωt=IRejωtRVRejωt=IRejωtR Where VR=VRejθtVR=VRejθt and IR=IRejθtIR=IRejθt are phasors. Both sides of the above equation can be divided by ejωt to yield: VR=IRR(4)VR=IRR(4) The impedance of a resistor is then determined from the definition of impedance: ZR=VRIR=R(5)ZR=VRIR=R(5) Thus: ZR = R           Impedance of a resistor The impedance of a resistor is a real number; that is, it has a magnitude R and a zero phase, as shown in Figure 2. The phase of the impedance is equal to the phase difference between the voltage across an element and the current through the same element. In the case of a resistor, the voltage is completely in phase with the current, which means that there is no time delay or time shift between the voltage waveform and the current waveform in the time domain. Figure 2 Phasor diagram of the impedance of a resistor. Remember that Z=V/L It is important to keep in mind that the phasor voltages and currents in AC circuits are functions of frequency, V = V (jω) and I = I (jω). This fact is crucial for determining the impedance of capacitors and inductors, as shown below. Impedance of an Inductor The i-v relationship for an inductor is (see Figure 3): Figure 3 For an inductor vL(t)=LdiL(t)dt(6)vL(t)=LdiL(t)dt(6) At this point, it is important to proceed carefully. The time-domain expression for the current through the inductor is: iL(t)=ILcos(ωt+θ)(7)iL(t)=ILcos⁡(ωt+θ)(7) Such that ddtiL(t)=−ILωsin(ωt+θ)=ILωcos(ωt+θ+π/2)=Re(ILωejπ/2ejωt+θ)=Re[IL(jω)ejωt+θ]ddtiL(t)=−ILωsin⁡(ωt+θ)=ILωcos⁡(ωt+θ+π/2)=Re⁡(ILωejπ/2ejωt+θ)=Re⁡[IL(jω)ejωt+θ] Notice that the net effect of the time derivative is to produce an extra ( j ω) term along with the complex exponential expression of iL(t). That is: Time Domain Frequency Domain d/dtd/dt jωjω Therefore, the phasor equivalent of the i-v relationship for an inductor is: VL=L(jω)IL(8)VL=L(jω)IL(8) The impedance of an inductor is then determined from the definition of impedance: ZL=VLIL=jωL(9)ZL=VLIL=jωL(9) Thus: ZL=jωL=ωL∠π2 Impedance of an inductor (10)ZL=jωL=ωL∠π2 Impedance of an inductor (10) The impedance of an inductor is a positive, purely imaginary number; that is, it has a magnitude of ωL and a phase of π/2 radians or 90◦, as shown in Figure 4. As before, the phase of the impedance is equal to the phase difference between the voltage across an element and the current through the same element. In the case of an inductor, the voltage leads the current by π/2 radians, which means that a feature (e.g., a zero crossing point) of the voltage waveform occurs T /4 seconds earlier than the same feature of the current waveform. T is the common period. Note that the inductor behaves as a complex frequency-dependent resistor and that its magnitude ωL is proportional to the angular frequency ω. Thus, an inductor will “impede” current flow in proportion to the frequency of the source signal. At low frequencies, an inductor acts like a short-circuit; at high frequencies, it acts like an open-circuit. Figure 4 Phasor diagram of the impedance of an inductor. Remember that Z=V/L Impedance of a Capacitor The principle of duality suggests that the procedure to derive the impedance of a capacitor should be a mirror image of the procedure shown above for an inductor. The i-v relationship for a capacitor is (see Figure 5): Figure 5 For a capacitor iC(t)=CdvC(t)dt(11)iC(t)=CdvC(t)dt(11) The time-domain expression for the voltage across the capacitor is: vC(t)=VCcos(ωt+θ)(12)vC(t)=VCcos⁡(ωt+θ)(12) Such that ddtvC(t)=−VCωsin(ωt+θ)=VCωcos(ωt+θ+π/2)=Re(VCωejπ/2ejωt+θ)=Re[VC(jω)ejωt+θ]ddtvC(t)=−VCωsin⁡(ωt+θ)=VCωcos⁡(ωt+θ+π/2)=Re⁡(VCωejπ/2ejωt+θ)=Re⁡[VC(jω)ejωt+θ] Notice that the net effect of the time derivative is to produce an extra ( j ω) term along with the complex exponential expression of vC(t). Therefore, the phasor equivalent of the i-v relationship for a capacitor is: IC=C(jω)VC(13)IC=C(jω)VC(13) The impedance of an inductor is then determined from the definition of impedance: ZC=VCIC=1jωC=−jωC(14)ZC=VCIC=1jωC=−jωC(14) Thus: ZC=1jωC=−jωC=1ωC∠−π2(15)ZC=1jωC=−jωC=1ωC∠−π2(15) The impedance of a capacitor is a negative, purely imaginary number; that is, it has a magnitude of 1/ωC and a phase of −π/2 radians or −90o, as shown in Figure 6. As before, the phase of the impedance is equal to the phase difference between the voltage across an element and the current through the same element. In the case of a capacitor, the voltage lags the current by π/2 radians, which means that a feature (e.g., a zero-crossing point) of the voltage waveform occurs T/4 seconds later than the same feature of the current waveform. T is the common period of each waveform. Figure 6 Phasor diagram of the impedance of a capacitor. Remember that Z=V/L Note that the capacitor also behaves as a complex frequency-dependent resistor, except that its magnitude 1/ωC is inversely proportional to the angular frequency ω. Thus, a capacitor will “impede” current flow in inverse proportion to the frequency of the source. At low frequencies, a capacitor acts like an open-circuit; at high frequencies, it acts like a short-circuit. Generalized Impedance The impedance concept is very useful in solving AC circuit analysis problems. It allows network theorems developed for DC circuits to be applied to AC circuits. The only difference is that complex arithmetic, rather than scalar arithmetic, must be employed to find the equivalent impedance. Figure 7 depicts ZR(jω), ZL(jω), and ZC(jω) in the complex plane. It is important to emphasize that although the impedance of resistors is purely real and the impedance of capacitors and inductors is purely imaginary, the equivalent impedance seen by a source in an arbitrary circuit can be complex. Figure 7 The impedance of R, L and C are shown in the complex plane. Impedances in the upper right quadrant are inductive while those in the lower right quadrant are capacitive. Z(jω)=R+X(jω)(16)Z(jω)=R+X(jω)(16) Here, R is resistance and X is reactance. The unit of R, X, and Z is the ohm. Admittance It was suggested that the solution of certain circuit analysis problems was handled more easily in terms of conductance’s than resistances. This is true, for example, when one is using node analysis, or in circuits with many parallel elements, since conductance in parallel add as resistors in series do. In AC circuit analysis, an analogous quantity may be defined—the reciprocal of complex impedance. Just as conductance G was defined as the inverse of resistance, admittance Y is defined as the inverse of impedance: Y=1Zunits of S (Siemens)(17)Y=1Zunits of S (Siemens)(17) Whenever the impedance Z is purely real, the admittance Y is identical to the conductance G. In general, however, Y is complex. Y=G+jB(18)Y=G+jB(18) where G is the AC conductance and B is the susceptance, which is analogous to reactance. Clearly, G and B are related to R and X; however, the relationship is not a simple inverse. If Z = R + jX , then the admittance is: Y=1Z=1R+jX(19)Y=1Z=1R+jX(19) Multiply the numerator and denominator by the complex conjugate Z ̄ = R − jX: Y=¯¯¯¯Z¯¯¯¯ZZ=R−jXR2+X2(20)Y=Z¯Z¯Z=R−jXR2+X2(20) and conclude that G=RR2+X2(21)B=−XR2+X2G=RR2+X2(21)B=−XR2+X2 Notice in particular that G is not the reciprocal of R in the general case! Did you find apk for android? You can find new Free Android Games and apps.

Leave a message 

Name *
Email *
Phone
Address
Code See the verification code? Click refresh!
Message
 

Message List

Comments Loading...
Home| About Us| Products| News| Download| Support| Feedback| Contact Us| Service

Contact: Zoey Zhang    Web: www.fmuser.net

Whatsapp/Wechat: +86 183 1924 4009

Skype: tomleequan     Email: [email protected] 

Facebook: FMUSERBROADCAST     Youtube: FMUSER ZOEY

Address in English: Room305, HuiLanGe, No.273 HuangPu Road West, TianHe District., GuangZhou, China, 510620    Address in Chinese: 广州市天河区黄埔大道西273号惠兰阁305(3E)